Ultra Trim Technique
Temporary Crown & Bridge Material

To achieve the best results follow these recommended techniques.

	TECHNIQUE

		a) Take a Supergel Alginate impression of tooth/teeth prior to final preparation.
		b) Load EZ-Squeeze with Ultra Trim cartridge in shade of choice.
		c) Extrude Ultra Trim directly into the impression.
		d) Cure and remove temporary from impression, cement into place.

	SPECIAL

Reseat the impression in the patient's mouth. Seat onto prepared areas of the teeth. Leave 2-3 minutes in mouth or until the material shows a hardened yet still elastic state. Remove the temporary from the impresion and trim/finish. Cement into place. If desired, material can be bench cured or placed the impression in the patient's mouth, seat onto the prepared areas of the teeth.

	CAUTION

*Once original cap is removed from cartridge, it should be discarded. *Extrude an initial 2mm of material onto mixing pad and discard, material following will be properly mixed. *Remove material in the rubbery state to avoid distruction. *The oxygen inhibited smear layer on the surface should be removed with tissue or alcohol. *Store material below room temperature 72°F (20°C).