TruSoft Intermediary Reline Technique
Resilient Acrylic Denture Relining Material

To achieve the best results follow these recommended techniques.

	TECHNIQUE

		a) Clean and dry denture thoroughly. Roughen tissue surface and periphery with a carbide bur. For enhanced bonding, Trusoft should extend over by border 2mm or be short of the periphery by 2mm.
		b) Coat buccal and labial surfaces, interproximal areas and occlusal surfaces of teeth and any opposing full or partial denture with Masque.
		c) Paint the denture with bonding liquid.
		d) Add 1 full measure of liquid (glass vial) to 1 full measure of powder (plastic vial) in permanent mixing cup. Spatulate for 30 seconds. Allow to stand for an additional 15 seconds. Pour into denture, spreading evenly over entire tissue surface.
		e) After 1 minute, denture is ready for insertion. Have patient close to occlusal contact position by applying pressure to labial surface.

	SPECIAL

Have patient hold for 4 to 5 minutes. There is no stinging or burning sensation and patient should remain comfortable. Remove and trim off excess.

	CONTRAINDICATIONS

Patient irritation and reactions have been known to occur with products that contain methacrylates. To minimize the risk of incidence; do not use this product on patients with a known sensitivity. Avoid repeated or prolonged contact with uncured material. Discontinue immediately if sensitization occurs.

	CAUTION

*Guard against protrusive position by applying pressure to labial surface. *Trimming can be best accomplished by using heated spatula, sharp knife or scissors. For final polish, use very wet slurry at low speed. *Do not heat-up denture by holding against buff wheel for long periods.